LINX joysticks

​

​

​

 

 

 

 

 

 

Error Codes The white round on/off key will flash red to indicate error codes when the LiNX controller detects an abnormal condition in the electrical system. The Main Round on/off key will flash a number of times quickly, then pause, then flash again. The on/off key will continue to flash the error codes until the problem is fixed. The following table identifies the individual error codes.

 

If any of these error codes persist or if you experience any other problem with your power chair, contact your authorized Provider. NOTE: When the on/off key flashes an error, the battery condition meter LEDs will also flash an inhibit. See “Battery Condition Meter.” Error Code Probable Cause Possible Solution

Number of Flashes (1-7)

1 Remote/joystick error Check cables and connectors. Replace remote.

2 Network or configuration error Check cables and connectors. Check Bluetooth pairing. Reconfigure the system. Recharge the battery. Check charger. Replace modules. Contact supplier.

3 Left motor fault Check the left motor, connections, and cables.

4 Right motor fault Check the right motor, connections, and cables.

5 Left park brake fault Check the left park brake, connections, and cables.

6 Right park brake fault Check the right park brake, connections, and cables.

7 Module error (other than Remote) Check cables and connectors. Check modules. Replace LiNX Access Key. Replace Power Module. Recharge battery. If the chair stalled, reverse away or remove obstacles, or if the chair was moved while turned off, cycle the power.