top of page
PG Drives New VSI error Flash codes

New VSI (hoveround)

New VSI Controller
1 flash: The battery needs charging or there is a bad
connection to the battery. Try charging the battery


2 flashes: The left hand motor has a bad connection.


3 flashes: The left hand motor has a short circuit to a battery connection.


4 flashes: The right hand motor has a bad connection.


5 flashes: The right hand motor has a short circuit to a battery connection


7 flashes: A joystick fault is indicted. Make sure that the joystick is in the center position before switching on the controller.


8 flashes: A controller fault is indicated.


9 flashes: Problem with the brake circuit. Check that the manual release levers are in the drive position.


10 flashes: An excessive voltage has been applied to the controller. This is usually caused by a poor battery connection.


Speed Bar Cycling: Controller locked.


Speed Gauge Cycling: Check if battery charger is still connected to controller or controller fault.

bottom of page